asp.net ean 13

asp.net ean 13

asp.net ean 13

asp.net ean 13

asp.net ean 13

asp.net ean 13,

asp.net ean 13,
asp.net ean 13,

asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,

asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,

asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,
asp.net ean 13,

Although a default Windows Server 2003 installation does not include routing capabil ities, the Windows Setup Wizard for Windows Server 2003 does install the Routing And Remote Access service in a disabled state. By using the Routing And Remote Access console, you can enable this service and configure many routing-type features, such as remote access, LAN routing, and NAT.

When you select the From Registry option for the Load Zone Data On Startup setting, the DNS server is initialized by reading parameters stored in the Windows Registry. When you select the From File option, the DNS server is initialized by reading parame ters stored in a boot file, such as those used by BIND servers. To use such a file, you should supply a copy of a boot file from a BIND-based DNS server. On BIND-based DNS servers, this file is typically called the Named.boot file. The format of this file must be the older BIND 4 format, not the more recent BIND 8 boot file format. When a boot file is used, settings in the file are applied to the server, overriding the settings stored in the Registry on the DNS server. However, for any parameters not configurable using boot file directives, Registry defaults (or stored reconfigured server settings) are applied by the DNS Server service.

focused on finding problems in the code. Less time is spent in meetings in which each person contributes only part of the time and in which a substantial amount of the effort goes into moderating group dynamics. Less time is spent delaying meetings until each person in the group can meet for two hours. Code readings are especially valuable in situations in which reviewers are geographically dispersed. A study of 13 reviews at AT&T found that the importance of the review meeting itself was overrated; 90 percent of the defects were found in preparation for the review meeting, and only about 10 percent were found during the review itself (Votta 1991, Glass 1999).

5-52

10. Under Authentication Methods, clear the Microsoft CHAP (MS-CHAP) check box. In VPN Strategy, click Try Layer Two Tunneling Protocol First (as shown in Figure 7-29). Click OK twice to return to the VPN Entries page, and then click Next.

5

Dog-and-pony shows are reviews in which a software product is demonstrated to a customer. Customer reviews are common in software developed for government contracts, which often stipulate that reviews will be held for requirements, design, and code. The purpose of a dog-and-pony show is to demonstrate to the customer that the project is OK, so it s a management review rather than a technical review. Don t rely on dog-and-pony shows to improve the technical quality of your products. Preparing for them might have an indirect effect on technical quality, but usually more time is spent in making good-looking Microsoft Powerpoint slides than in improving the quality of the software. Rely on inspections, walkthroughs, or code reading for technical quality improvements.

By default, the Enable Automatic Scavenging Of Stale Records option is cleared on the Advanced tab. According to this setting, DNS servers in Windows Server 2003 by default do not automatically delete stale or outdated resource records from a zone for which Aging has been enabled. When this setting is enabled, scavenging of stale resource records is performed auto matically at the interval configured in the Scavenging Period.

/********************************************************************** class: GigaTron (GIGATRON.CPP)